If the car owner has basic knowledge regarding how to change car oil by using correct parts, then it is very easy to do this process by his own self. It is the most modest process that requires only a few tools, and it’s a sure way to save some money while to avoid the hassle of sitting in a dull waiting room somewhere reading outdated magazines.

The most important thing, the basic oil change is a great way to connect with the vehicle and take some control over its care. If the vehicle performs well during a drive it gives an opportunity to enjoy the beauty of nature outside the car. Here are a few key points to remember how to use oil change parts during the completion of this oil changing method.

Time schedule: 

Approximately it required one hour the first time out is 30 minutes on average.

Main Tools Which Required:

  • Car knave and knave stands
  • Oil
  • Oil Filter
  • Funnel
  • Oil drain pan (try to use heat resistant)
  • Socket pull
  • Rubber gloves
  • Paper towels
  •  Old towel
  • Rags
  • Wrench set

The manufacturer’s manual can be helpful to know what type of oil is best to use for the car. Also, collect information about the year, make, model, and the engine dislodgment size to determine the type of filter which needs.

Remove your scrap car today: Free Car Removals

The Oil Changing Procedure:

First of all, lift the vehicle by using the jack before starting the process. Before to start this process, run the car for one or two because warm oil flows out smoothly. Then, use a jack that can hoist the vehicle at a stature where it can comfortably crawl under it. The person can also use the jack stand to ensure that the car won’t fall on top of him.

Drain the Oil:

Locate the drain plug which looks like a bolt and put the oil drain pan directly below it. Don’t forget to use rubber gloves and loosen the plug by using a socket wrench. Once it’s unfastened, unscrew this plug and remove it by hand. The oil will start to come out. Let the car be unfilled and then screw the bolt. Wipe off the spilled oil with paper towels.

Replace the Oil Filter:

Now it’s time to remove the oil filter after moving the oil pan which is placed under it. Some more oil will spill out. Wipe off the opening part with paper towels. Dab some oil along the new filter’s rim, left this part if it’s a paper filter. Place a new at the right place and tighten the seal with hand.

Refill the Oil:

Carefully go through the manual to know how much oil a car needs. Just remove the oil cap, put a funnel in the hole, and start pouring oil. When it’s done, place the cap and tighten it.

Take off the jack and turn on the engine so that the oil could run through the system. Don’t forget to check the oil level with a dipstick to know if the tank has been filled.

Don’t dump the removed oil in an unapproved zone. Just tip it into a container and take to a gas station or auto parts store those who buy or take this used oil for other purposes. It is necessary to purchase so that they match the automobile’s specifications.

Oil Additives:

The use of additives is really a good approach that helps to improve and maintaining oil performance. High engine temperatures combine with humidity, combustion of byproducts, rust, erosion, engine-wear particles, and oxygen to produce more and varnish. The additives not only give help to car oil in maintaining good lubrication but they also minimize sludge and varnish, and any damage from their formation.

That was a small overview to help the car owners how they can easily change car oil by their own selves.

Avail free car removal: Free Car Removals Melbourne